Roaming Sensitivity Page

If you set this to "Low" or "Conservative," your device will stubbornly hold onto the current Access Point until the signal is nearly dead.

If your network feels sluggish but your speed tests are fine, or if your calls drop while walking around the house, don't just blame the router. Check your roaming sensitivity. You might just be holding on too tight—or letting go too soon. roaming sensitivity

In high-density environments with many overlapping Wi-Fi signals (like apartment buildings), a device set to "Highest" sensitivity might switch between two different APs constantly. This "flapping" causes brief disconnections during each handoff. In this case, lowering the sensitivity to "Medium" or "Low" can stabilize the connection. How to Change Roaming Sensitivity in Windows If you set this to "Low" or "Conservative,"

If you walk from your living room (where the router is) to your home office (where there is a signal booster) and your laptop stays connected to the weak living room signal, your roaming sensitivity is likely too . Increasing it to "High" or "Medium-High" forces the device to hand off to the closer office booster sooner. 2. Connection "Flapping" You might just be holding on too tight—or

Do you walk around the office on Wi-Fi calls and notice brief audio dropouts every few minutes? Your device might be switching Access Points too aggressively. Lowering the sensitivity forces the device to stick with the current router longer, prioritizing connection stability over raw signal strength.